Garage Floor Coatings in Bucks & Montgomery County, PA

Your garage floor takes more abuse than any surface in your house from road salt, oil drips, hot tires, dropped tools. We install one day polyaspartic and epoxy floor coatings for homeowners across Bucks and Montgomery County, and most floors are ready to walk on the same night. Call (267) 878-3165 for a free quote, most estimates take one short conversation and a few photos.

Email Us

dan@buxmontgaragefloors.com

Call Us

(267) 878-3165

location

Bucks & Montgomery County, PA

Why Choose Us

Why Buxmont Homeowners Coat Their Floors

Road salt is eating your slab. PennDOT and the townships brine the roads before every storm, and that salt rides home on your car and drips onto bare concrete all winter. Salt doesn’t just stain, it works into the pores of the slab and breaks down the surface, which is why so many local garage floors are pitted and dusty. A coated floor seals the concrete so salt and slush sit on top until you push a squeegee across them.

  • One-day installation — park on it in 24 hours
  • Polyaspartic topcoat (no hot-tire peel, no yellowing)
  • Sealed against salt, oil, and stains
How It Works

Our Coating Process

1. Grind the Concrete

Diamond grinders open the pores of the slab so the coating locks in

2. Repair Cracks

Hairline cracks and chips get filled with fast curing polymer patch so nothing telegraphs through the finish

3. Base Coat

A pigmented polyaspartic base bonds directly into the ground concrete and does the heavy lifting

4. full Flake Broadcast

Vinyl color flakes go down until the floor won’t hold more – thickness, texture, and the finished look

5. clear Topcoat

A UV stable polyaspartic topcoat seals it all: no yellowing, no hot-tire peel, shrugs off salt and oil

6. Park in 24 Hours

Walk on it that evening, and park the next day. One day, start to finish, for most two-car garages

Pricing

What It Costs

Straight answer: professionally installed floor coatings in this market run $4 to $12 per square foot. A typical two car garage around here is 400–500 square feet, so most homeowners land between $2,000 and $4,500 for a full-flake system. Call (267) 878-3165 for your floor’s exact number

Slab Condition

A newer floor that needs standard grinding sits at the low end. Heavy cracking, spalling, or stripping an old coating adds labor.

moisture

Older slabs can wick ground moisture up through the concrete. Those need a mitigating primer first and more up front, but it keeps the floor from delaminating later.

Size & System

Bigger floors cost less per square foot. Single-color epoxy runs cheaper than full-flake polyaspartic, but flake hides scratches and wears better.

Service Area

Where We Work

We install garage floor coatings throughout Central Bucks County and Eastern Montgomery County — plus the surrounding townships. If you’re nearby but don’t see your town, call anyway. We’re local, and the answer is usually yes.

Central Bucks

Doylestown, Warrington, Warminster, Chalfont, Jamison, Newtown


Eastern Montco & Route 611

Lansdale, Blue Bell, Harleysville, Horsham

Frequently Asked Questions

How long does the install take?

One day for most two-car garages. We start in the morning; you can typically walk on the floor that evening and park on it after 24 hours. Bigger or badly damaged floors occasionally need a second day.

When can I park on it?

 Light foot traffic the same night, cars after about 24 hours. We’ll give you exact timing on installation day, it varies a little with temperature and humidity.

Can you install in winter?

Yes. Polyaspartic coatings cure properly in cold temperatures. Winter is actually a smart time to book: your floor gets protected before the worst of the salt season, and schedules are easier.

Epoxy vs. polyaspartic — what’s the difference?

Epoxy is the older chemistry: cheaper, slower to cure, and prone to yellowing in sunlight and softening under hot tires. Polyaspartic cures fast, stays clear under UV, and handles temperature swings, which is why we use it for topcoats. Many quality systems use both: an epoxy or polyaspartic base for build, polyaspartic on top for durability.

Is the floor slippery when wet?

 The flake broadcast gives the surface a light orange-peel texture that adds grip. For extra traction — say, near the door where snowmelt puddles — we can add a grit additive to the topcoat. Just ask when you book.

Ready for a floor you don’t have to apologize for? Call (267) 878-3165 for a free, no-pressure quote.

Free Quote

Prefer to Type? Get Your Free Quote Here.

Tell us about your floor and we’ll get back to you within one business day with a ballpark and next steps.

Mon – Sat

8:00 — 6:00

Call to ask any question

(267) 878-3165